facebook1 youtube1 twitter1 instagram linkedin1 pinterest1

NOTICE:  If you are not a free registered member of the site, you will not see the photos in the forum, and you won't be able to access our premium member content. Please consider joining our community! REGISTER AND MAKE THIS BOX DISAPPEAR!

×

Pictures Posting Not Working (12 Jun 2023)

Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.

Makotosun

Help needed CT3 crank

  • Pete-RT1
  • Pete-RT1's Avatar Topic Author
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 1067
  • Likes received: 1713

Replied by Pete-RT1 on topic Help needed CT3 crank

"How are you for a wiring loom, Pete.......?! "

Alan, bike has the original loom, so hopefully will be fine 

This image is hidden for guests.
Please log in or register to see it.


​​​​​​​
Yamaha CT1-B The Greenie
Yamaha CT1-C
Yamaha CT1-C The Doppelgänger 2
Yamaha CT1-C The Doppelgänger 3
Yamaha AT1-C
Yamaha CT3 (in bits)
1980 CB250RS (The Project)
2020 Honda CB500X
02 Jul 2021 13:41 #21

Please Log in or Create an account to join the conversation.

  • Posts: 1070
  • Likes received: 675

Replied by shyted on topic Help needed CT3 crank

Mint job.
Do you have or is that a new O ring seal on the primary side Pete ?
I take it you have a map gas torch too?
The following user(s) Liked this Post: Rick C.
02 Jul 2021 15:56 #22

Please Log in or Create an account to join the conversation.

  • Pete-RT1
  • Pete-RT1's Avatar Topic Author
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 1067
  • Likes received: 1713

Replied by Pete-RT1 on topic Help needed CT3 crank

New seal fitted Dave.
I noticed that my cooking skills when I installed the bearings into the cases caused two hole blanking plugs to fall out from the crankcase behind the magneto.
I'm guessing the holes are for tooling during case manufacture and are blanked after.
I have one plug, found in the oven and I think I can find the other in the garage rubbish bag.
Options are:
Leave it as it is.
Fill with JB Weld.
Bond back in the original plugs. Not sure what I would use that would guarantee they didn't come back out and damage stator etc.
Anyone had this before?
  
Yamaha CT1-B The Greenie
Yamaha CT1-C
Yamaha CT1-C The Doppelgänger 2
Yamaha CT1-C The Doppelgänger 3
Yamaha AT1-C
Yamaha CT3 (in bits)
1980 CB250RS (The Project)
2020 Honda CB500X
03 Jul 2021 11:39 #23

This message has attachments images.
Please log in or register to see it.

Please Log in or Create an account to join the conversation.

Moderators: yamadmin, Makotosun, DEET, Vinnie, James Hart