facebook1 youtube1 twitter1 instagram linkedin1 pinterest1

NOTICE:  If you are not a free registered member of the site, you will not see the photos in the forum, and you won't be able to access our premium member content. Please consider joining our community! REGISTER AND MAKE THIS BOX DISAPPEAR!

×

Pictures Posting Not Working (12 Jun 2023)

Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.

Makotosun

RT3 will not start - SOS

  • Posts: 9735
  • Likes received: 3981

Replied by RT325 on topic RT3 will not start - SOS

 I know i "& others" keep mentioning the flywheel key & hope the poster isn't getting annoyed at pushing the point--but paid off in the end. So you'll never get caught out by that problem again. I'll find a pic of my "never fail" over the top method of tightening but cranks on my fleet were mostly pretty bad from being destroyed previously. Good that APEX #16 pushed the point harder.
The following user(s) Liked this Post: Jogar
Last edit: 15 Oct 2021 13:45 by RT325.
15 Oct 2021 13:35 #21

This message has an attachment image.
Please log in or register to see it.

Please Log in or Create an account to join the conversation.

  • Posts: 9735
  • Likes received: 3981

Replied by RT325 on topic RT3 will not start - SOS

& be sure the puller is fully engaged which means no washers sitting in there so it uses all the fine thread before the puller bolt touches the crank--back the puller bolt way out before screwing the puller body in.
Was thinking i was adding this under DEET #18 but anyway, easy to pull that 27mm fine thread if only half screwed in.
The following user(s) Liked this Post: Jogar
Last edit: 15 Oct 2021 13:53 by RT325.
15 Oct 2021 13:51 #22

Please Log in or Create an account to join the conversation.

Moderators: yamadmin, Makotosun, DEET, Vinnie, James Hart