facebook1 youtube1 twitter1 instagram linkedin1 pinterest1

NOTICE:  If you are not a free registered member of the site, you will not see the photos in the forum, and you won't be able to access our premium member content. Please consider joining our community! REGISTER AND MAKE THIS BOX DISAPPEAR!

×

Pictures Posting Not Working (12 Jun 2023)

Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.

Makotosun

At/ct seal questions

  • Papawhellie
  • Papawhellie's Avatar Topic Author
  • Offline
  • Premium Member
  • Premium Member
  • Posts: 127
  • Likes received: 25

At/ct seal questions was created by Papawhellie

On the trans diagram it shows push rod seal 93109-06060-00. Where is this located and it it replaced without splitting cases? Also the IT crank seal Mark T mentioned on an old post 93103-25125-00 I assume will fit the AT As the AT/CT seal part number is the same?
22 Jan 2023 09:15 #1

Please Log in or Create an account to join the conversation.

  • Posts: 13493
  • Likes received: 9346

Replied by MarkT on topic At/ct seal questions

Pushrod seal is located under side cover just forward and above the drive sprocket. 

I'm not aware of any oil seal on a Yamaha Enduro that requires case splitting to change...  clutch pushrod seal on AT/CT definitely does not.

And yes, crank seals are the same size on all the Yamaha 125/175 Enduros from 1969 to 1981.  IT175 seal works  on any of them. 

 
1963 YG1-T, 1965 MG1-T, Allstate 250, 1970 CT1b, 1971 R5, 1973 AT3MX, 1974 TS400L, 1975 RD350, 1976 DT175C, 1976 Husqvarna 250CR, 1981 DT175G, 1988 DT50, 1990 "Super" DT50, 1991 RT180, 2017 XT250
The following user(s) Liked this Post: shyted, JayB, Schu, Ht1kid
22 Jan 2023 10:44 #2

Please Log in or Create an account to join the conversation.

Moderators: yamadmin, Makotosun, DEET, Vinnie, James Hart