×
Pictures Posting Not Working (12 Jun 2023)
Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.
Makotosun
Axle Spacer Flange
- Phils2888
- Topic Author
- Offline
- Premium Member
- Posts: 68
- Likes received: 16
Axle Spacer Flange was created by Phils2888
I just got new spacers from Yamaha 93210-42101 for my 1970 250, and they are much smaller than the original. Actually the rear hub did not have any flange, so I only have one original flange from the front hub. Take a look at the size difference in the originals and the “replacements”. I’m not sure if they will even fit on the spacer and since they are much smaller on the outside diameter, will they really do any good in that hub void.
29 Sep 2020 17:57
#1
This message has an attachment image.
Please log in or register to see it.
Please Log in or Create an account to join the conversation.
- apex
- Offline
- Content Contributor
- Posts: 779
- Likes received: 860
Replied by apex on topic Axle Spacer Flange
93210-42101 with the -00 on the end is an o ring, #11 in the diagram. I don't see another part with a 93210 prefix, and I don't recognize the part you need in the photo. What # in the diagram is it you need?
Allrighty Then
29 Sep 2020 18:12
#2
This message has an attachment image.
Please log in or register to see it.
Please Log in or Create an account to join the conversation.
- DEET
- Offline
- Moderator
- Posts: 1408
- Likes received: 1294
Replied by DEET on topic Axle Spacer Flange
Free tip..... use an o-ring or two.
This email address is being protected from spambots. You need JavaScript enabled to view it.
Where the Yamaha Enduro is still a current model...
Where the Yamaha Enduro is still a current model...
29 Sep 2020 20:42
#3
Please Log in or Create an account to join the conversation.
- Phils2888
- Topic Author
- Offline
- Premium Member
- Posts: 68
- Likes received: 16
Replied by Phils2888 on topic Axle Spacer Flange
Ok, I typed the wrong part number in, My apologies but my photo had the correct Part number for the flange, 146-25116, which would be part#8 in the illustration but is cut off in your picture.
30 Sep 2020 04:45
#4
Please Log in or Create an account to join the conversation.
Moderators: yamadmin, Makotosun, DEET, Vinnie, James Hart