×
Pictures Posting Not Working (12 Jun 2023)
Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.
Makotosun
DT250B standard spring rates?
- Von
- Topic Author
- Offline
- Senior Member
- Posts: 49
- Likes received: 18
DT250B standard spring rates? was created by Von
Maybe someone here will know, what are the standard spring rates on the DT250B in either N-M or Ib -inch ?
Thanks, Tom
Thanks, Tom
The following user(s) Liked this Post: MACE6772
19 Sep 2020 06:59
#1
Please Log in or Create an account to join the conversation.
- MACE6772
- Offline
- Site Supporter
- Posts: 206
- Likes received: 150
Replied by MACE6772 on topic DT250B standard spring rates?
I too need this answered. I am looking to have new springs made for resale.
76 Dt 125 75 Dt 175 75 Dt 250 75 Dt 400 09 FZ6R
19 Sep 2020 07:28
#2
Please Log in or Create an account to join the conversation.
- Swoop56
- Offline
- Site Supporter
- Posts: 1120
- Likes received: 696
Replied by Swoop56 on topic DT250B standard spring rates?
Front or rear ?
20 Sep 2020 00:33
#3
Please Log in or Create an account to join the conversation.
- Hammer
- Offline
- Platinum Member
- Posts: 392
- Likes received: 248
Replied by Hammer on topic DT250B standard spring rates?
Von,
Do you mean for the DT-1B, vice the later DT250s? Just curious.
Hammer
Do you mean for the DT-1B, vice the later DT250s? Just curious.
Hammer
Who, More than Self, His Country Loved.
20 Sep 2020 00:47
#4
Please Log in or Create an account to join the conversation.
- Von
- Topic Author
- Offline
- Senior Member
- Posts: 49
- Likes received: 18
Replied by Von on topic DT250B standard spring rates?
1975 DT250B rear springs.
20 Sep 2020 01:43
#5
Please Log in or Create an account to join the conversation.
- Swoop56
- Offline
- Site Supporter
- Posts: 1120
- Likes received: 696
Replied by Swoop56 on topic DT250B standard spring rates?
My DT 250 B Specification sheet has these figures .
Free length 224.4 mm
Spring rate K1 = 1.42 kgs / mm
K2 = 2.6 kgs / mm
Hope that helps , but probably not exactly what you were hoping to get .
Free length 224.4 mm
Spring rate K1 = 1.42 kgs / mm
K2 = 2.6 kgs / mm
Hope that helps , but probably not exactly what you were hoping to get .
The following user(s) Liked this Post: MACE6772, Von
Please Log in or Create an account to join the conversation.
- Shane86
- Offline
- Junior Member
- Posts: 17
- Likes received: 12
Replied by Shane86 on topic DT250B standard spring rates?
I measured my DT250A springs at 75 lb per inch for each spring. This is a little less than the spec sheet but close. I also think some springs have a dual rate coil
The following user(s) Liked this Post: MACE6772, Von
21 Sep 2020 18:19
#7
Please Log in or Create an account to join the conversation.
Moderators: yamadmin, Makotosun, DEET, Vinnie, James Hart