facebook1 youtube1 twitter1 instagram linkedin1 pinterest1

NOTICE:  If you are not a free registered member of the site, you will not see the photos in the forum, and you won't be able to access our premium member content. Please consider joining our community! REGISTER AND MAKE THIS BOX DISAPPEAR!

×

Pictures Posting Not Working (12 Jun 2023)

Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.

Makotosun

clutch ball bearing

  • Tdbecker58
  • Tdbecker58's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 8
  • Likes received: 0

clutch ball bearing was created by Tdbecker58

I am working on my 1972 125 AT2-M and have a question about the clutch push rod and bearing.  when I disassembled it, I noticed that the little ball was missing.  I replaced it with the same size as described in the Service Manual. (1/4").   Now I cannot get the left crank case cover to close.  I've seen a lot of discussion about this assembly, but cannot figure out if I need the ball bearing or not.   This AT2-M is a tricky bike.  

This image is hidden for guests.
Please log in or register to see it.




I have tried to adjust the push screw, but it has no impacted.  Maybe the push rod 2 is too long???? 

Thanks for any help!!

Terry 

PS... still looking for an air box (any thing to get it raceable.)   
13 Jun 2021 05:49 #1

Please Log in or Create an account to join the conversation.

Moderators: yamadmin, Makotosun, DEET, Vinnie, James Hart