Hi all, I recently got a pretty bare stripped down DT3 roller. I need some help getting the wires from the mag hooked up to see if there is spark. It did not have coil so I bought one on ebay. It has one black male wire. I looked at several wiring diagrams and searched the forum but could not really find something that would show me what must be connected. Getting a flywheel puller soon. Looks pretty clean in there so I am fairly optimist that things should not be too bad electrically. Thanks in advance for your comments.

Black to black. Ignore everything else. Tee a kill switch into black that grounds the black for a kill switch.



Ignore the other wires. Just make sure they don't ground out. They are for lights.

I was hoping it was that simple.

Thanks so much! I will let you know ASAP.