facebook1 youtube1 twitter1 instagram linkedin1 pinterest1

NOTICE:  If you are not a free registered member of the site, you will not see the photos in the forum, and you won't be able to access our premium member content. Please consider joining our community! REGISTER AND MAKE THIS BOX DISAPPEAR!

×

Pictures Posting Not Working (12 Jun 2023)

Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.

Makotosun

Too much side to side play in gear selector shaft???

  • rickwrenchbender
  • rickwrenchbender's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 8
  • Likes received: 0

Too much side to side play in gear selector shaft??? was created by rickwrenchbender

Upon final assembly of my 1975 dt250..while installing a brand new shifter arm.,I noticed a considerable amount of in and out,left to right play in the selector shaft..about 1/4 inch...that seems like alot..the eclip is on the left side with a new seal...is it common for the eclip on the right side to fall of or some type of wear to happen causing this.,the bike only has 3200 miles on it..any input is much appreciated..
16 Aug 2021 12:41 #1

Please Log in or Create an account to join the conversation.

  • Posts: 1207
  • Likes received: 790

Replied by Swoop56 on topic Too much side to side play in gear selector shaft???

Parts book shows a washer between the e clip and the seal .
Is yours in place ?
The following user(s) Liked this Post: RT325
16 Aug 2021 17:43 #2

Please Log in or Create an account to join the conversation.

  • Posts: 1058
  • Likes received: 668

Replied by shyted on topic Too much side to side play in gear selector shaft???

Is that built up without the outer case cover on ? Check the outer case if not there might be a stopper built into it. It will be a protruding ally sprag with a flat top.
17 Aug 2021 04:27 #3

Please Log in or Create an account to join the conversation.

Moderators: yamadmin, Makotosun, DEET, Vinnie, James Hart