facebook1 youtube1 twitter1 instagram linkedin1 pinterest1

NOTICE:  If you are not a free registered member of the site, you will not see the photos in the forum, and you won't be able to access our premium member content. Please consider joining our community! REGISTER AND MAKE THIS BOX DISAPPEAR!

×

Pictures Posting Not Working (12 Jun 2023)

Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.

Makotosun

AT1MX pistons

  • Benjamin Fennell
  • Benjamin Fennell's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 2
  • Likes received: 0

AT1MX pistons was created by Benjamin Fennell

hi , can i run a 2 ring ATI piston in the AT1MX clyinder?
07 Nov 2023 13:24 #1

Please Log in or Create an account to join the conversation.

  • Posts: 9718
  • Likes received: 3969

Replied by RT325 on topic AT1MX pistons

Probably can, but best to check where the ring peg [ring end gap] is for the lower ring at bdc. viewing in the inlet port.
Worst case is you'll just have to run the top ring only. My guess is it'll be ok but only one way to be sure.
Also the piston shirt on the inlet side will be slightly longer on the two ring piston, but won't hurt to shorten it to match unless there's strengthening bits inside the skirt at the bottom that will be removed.
07 Nov 2023 23:47 #2

Please Log in or Create an account to join the conversation.

Moderators: yamadmin, Makotosun, DEET, Vinnie, James Hart